![]() Any suggestions, any way around that?I'll help you undeerstand how others may see this as a problem.Ī- I got a "free" version of a newer MasterCam.Ī free version refers to an "unpaid, unlicensed copy"ī- I got the disks and manuals, but no "key" to enable it. I got the disks and manuals, but no "key" to enable it. ![]() I got a "free" version of a newer MasterCam. Would you be divulging to much about the cliffhanger by filling me in? Looking back I may have worded my post differently, but there's response there from a few haters who would have found fault anyway.īy the way Doug, no I musta missed that episode of the Jesse James show while working. If I have nothing good to say, I say nothing. I keep my posts on PM on the positive side. I was looking for a way to try the new version on my laptop at home. ![]() With older versions of MC you could use the software on another pc, but couldn't post code or save programs. I got the upgraded software months ago, but since we don't do any 3D milling it sat in the box until recently. I was given MC X2 and told I'd receive X3 when it was released. When I purchased my "seat" for MC X3 the software was being "debugged", or something to that effect. ![]() Thanks to all the moral police for their goodwill and advice. I also have, bought and paid for, MC 7, 8, and 9. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |